Repository logo
 

Characterization of a plasma reactor device for photovoltaic applications

Simple item page
dc.contributor.authorMetz, Garrett Eugene, author
dc.contributor.authorWilliams, John D., advisor
dc.contributor.authorMahoney, Leonard, committee member
dc.contributor.authorSampath, Walajabad S., committee member
dc.contributor.authorRobinson, Steve, committee member
dc.date.accessioned2007-01-03T08:34:16Z
dc.date.available2007-01-03T08:34:16Z
dc.date.issued2012
dc.description.abstractHeated pocket deposition (HPD) sources are used for the rapid manufacture of thin film CdS/CdTe photovoltaic devices. Standard lab devices produced at CSU by the HPD process have achieved efficiencies of 13%. New process methods are required to further improve the quality of the films, increase cell efficiency, and reduce production costs. A plasma-enhanced, close-spacing sublimation (PECSS) technique has recently been developed as a candidate process method. It has been successfully used to eliminate pin holes, to dope CdS with oxygen, and dope CdTe absorption layers; all of which have resulted in higher device efficiencies. In this work we present measurements describing the properties of the PECSS plasma. Specifically the uniformity of the ion current flux to the substrate is presented for nitrogen/oxygen and argon feed gases by means of in situ surface probes fabricated by segmenting a transparent conductive oxide film that is laid over the glass. Plasma properties within the PECSS processing chamber are also presented including plasma density, electron temperature, and plasma potential. Operational characteristics and scaling of PECSS are presented for pressures of 100-300 mTorr and surface areas of 160 - 1700 cm2. A three-dimensional model was developed to calculate plasma production and transport processes, and to gain a greater understanding of the role of energetic primaries versus bulk cold electrons on spatial ionization rates that develop within the PECSS plasma as a function of gas pressure and geometry. Comparisons between the model and experimental measurements are presented and good agreement has been observed when the appropriate spatially varying ionization rates are estimated. This work also presents the development of a diagnostic test bed that will be useful for future work in the development and understanding of the PECSS technique.
dc.format.mediumborn digital
dc.format.mediummasters theses
dc.identifierMetz_colostate_0053N_11518.pdf
dc.identifierETDF2012400436MCEN
dc.identifier.urihttp://hdl.handle.net/10217/74526
dc.languageEnglish
dc.language.isoeng
dc.publisherColorado State University. Libraries
dc.relation.ispartof2000-2019
dc.rightsCopyright and other restrictions may apply. User is responsible for compliance with all applicable laws. For information about copyright law, please see https://libguides.colostate.edu/copyright.
dc.titleCharacterization of a plasma reactor device for photovoltaic applications
dc.typeText
dcterms.rights.dplaThis Item is protected by copyright and/or related rights (https://rightsstatements.org/vocab/InC/1.0/). You are free to use this Item in any way that is permitted by the copyright and related rights legislation that applies to your use. For other uses you need to obtain permission from the rights-holder(s).
thesis.degree.disciplineMechanical Engineering
thesis.degree.grantorColorado State University
thesis.degree.levelMasters
thesis.degree.nameMaster of Science (M.S.)

Files

Original bundle
Now showing 1 - 1 of 1
Thumbnail Image
Name:
Metz_colostate_0053N_11518.pdf
Size:
1.88 MB
Format:
Adobe Portable Document Format
Description:
Download

Collections

2000-2019
Theses and Dissertations