Menon, Arun B., authorDuff, William, advisorBurns, Patrick J., committee memberZachmann, David W., committee member2024-09-252024-09-251994https://hdl.handle.net/10217/239489Covers not scanned.Print version deaccessioned 2024.The optical efficiency of a solar collector, which depends on the collector geometry and material properties (i.e., geometry and radiative properties of the cover, absorber and any reflector), contributes significantly towards its overall performance. This optical efficiency is directly proportional to the transmittance-absorptance or τα product for all possible angles of incidence. A 3-D Monte Carlo ray tracing technique is used to determine this τα product for evacuated tubular collectors (ETCs) with cylindrical absorbers in an effort to identify the most efficient optical design parameters. These collectors are asymmetric with respect to the incident solar radiation and their optical efficiencies are therefore difficult to estimate using any other method. The collector geometry is modeled using constructive solid geometry (CSG). CSG allows the generation of complex collector shapes by combining simple primitive objects. The ray tracing algorithm tracks individual photons through the collector geometry to provide a means of obtaining the absorbed fraction for a particular angle of radiation incident on the collector plane. Incidence angle modifiers (IAMs), the ratio of the τα product at a particular set of longitudinal and transverse radiation incidence angles to the τα product at normal incidence are thereby obtained. IAMs are calculated for variations in five different design parameters to determine the most advantageous geometries. It is found that diffusely reflecting back planes significantly enhance optical performance of tubular collectors. Verification of the ray trace calculations is made by comparing with experimental results from the indoor solar simulator at CSU. TRNSYS predicted values of τα are within 1% of the ray trace results for normal incidence tests and within 7% for off-normal tests. Inaccuracies resulting from the use of a multiplicative technique wherein off-axis IAMs are obtained by a multiplicative combination of the biaxial IAMs are also addressed. The multiplicative approach is found to be very inaccurate for angles of incidence greater than 40°. To further assess the relative advantages of tubular collectors over flat plate collectors and whether a reflective back plane is really necessary, the two types of collectors are modeled in a simple fashion and the amount of radiation that is available for collection by each is determined. Calculations show that reflectors would probably not be required for collector slopes in excess of 50°. However, for slope angles less than 50°, a reflector placed behind the tubes is beneficial.masters thesesengCopyright and other restrictions may apply. User is responsible for compliance with all applicable laws. For information about copyright law, please see https://libguides.colostate.edu/copyright.Solar collectors -- Design and constructionText